User's Manual

Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters the command mode for the adapter card at the PCI
slot number specified by index.
Server /chassis # scope adapter
index
Step 2
The server must be powered on before you can
view or change adapter settings.
Note
Enters the host Fibre Channel interface command mode
for the specified vHBA.
Server /chassis/adapter # scope
host-fc-if {fc0 | fc1 | name}
Step 3
Creates a boot table entry.Server /chassis/adapter/host-fc-if #
create-boot-entry wwpn lun-id
Step 4
• wwpn — The World Wide Port Name (WWPN) for
the boot target in the form hh:hh:hh:hh:hh:hh:hh:hh.
• lun-id —The LUN ID of the boot LUN. The range
is 0 to 255.
Commits the transaction to the system configuration.Server /chassis/adapter/host-fc-if #
commit
Step 5
The changes will take effect upon the next server
reboot.
Note
This example creates a boot table entry for vHBA fc1:
Server# scope chassis
Server /chassis # scope adapter 1
Server /chassis/adapter # scope host-fc-if fc1
Server /chassis/adapter/host-fc-if # create-boot-entry 20:00:00:11:22:33:44:55 3
Server /chassis/adapter/host-fc-if *# commit
New boot table entry will take effect upon the next server reset
Server /chassis/adapter/host-fc-if #
Deleting a Boot Table Entry
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters the command mode for the adapter card at the PCI
slot number specified by index.
Server /chassis # scope adapter
index
Step 2
The server must be powered on before you can
view or change adapter settings.
Note
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 95
Managing Network Adapters
Deleting a Boot Table Entry