User's Manual

PurposeCommand or Action
Enters the interrupt command mode.Server /chassis/adapter/host-fc-if # scope
interrupt
Step 23
Specifies the Fibre Channel interrupt mode. The
modes are as follows:
Server
/chassis/adapter/host-fc-if/interrupt # set
interrupt-mode {intx | msi | msix}
Step 24
• intx —Line-based interrupt (INTx)
• msi —Message-Signaled Interrupt (MSI)
• msix —Message Signaled Interrupts with the
optional extension (MSIx). This is the
recommended and default option.
Exits to the host Fibre Channel interface command
mode.
Server
/chassis/adapter/host-fc-if/interrupt # exit
Step 25
Enters the Fibre Channel port command mode.Server /chassis/adapter/host-fc-if # scope
port
Step 26
Specifies the I/O throttle count, the number of I/O
operations that can be pending in the vHBA at one
Server /chassis/adapter/host-fc-if/port #
set outstanding-io-count count
Step 27
time. The range is 1 to 1024; the default is 512
operations.
Specifies the maximum logical unit numbers (LUNs)
per target, the maximum number of LUNs that the
Server /chassis/adapter/host-fc-if/port #
set max-target-luns count
Step 28
driver will discover. This is usually an operating
system platform limitation. The range is 1 to 1024;
the default is 256 LUNs.
Exits to the host Fibre Channel interface command
mode.
Server /chassis/adapter/host-fc-if/port #
exit
Step 29
Enters the Fibre Channel fabric login command mode.Server /chassis/adapter/host-fc-if # scope
port-f-logi
Step 30
Specifies the fabric login (FLOGI) retries value, the
number of times that the system tries to log in to the
Server
/chassis/adapter/host-fc-if/port-f-logi #
set flogi-retries {infinite | count}
Step 31
fabric after the first failure. Enter a number between
0 and 4294967295 or enter infinite ; the default is
infinite retries.
Specifies the fabric login (FLOGI) timeout value, the
number of milliseconds that the system waits before
Server
/chassis/adapter/host-fc-if/port-f-logi #
set flogi-timeout msec
Step 32
it tries to log in again. The range is 1 to 255000; the
default is 2000 milliseconds.
Exits to the host Fibre Channel interface command
mode.
Server
/chassis/adapter/host-fc-if/port-f-logi #
exit
Step 33
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
90 OL-28893-01
Managing Network Adapters
Modifying vHBA Properties