User's Manual

If Network Interface Virtualization (NIV) mode is enabled for the adapter, you must
assign a channel number to a vHBA when you create it.
Note
•
When using the Cisco UCS P81E Virtual Interface Card or Cisco UCS VIC1225 Virtual Interface Card
in an FCoE application, you must associate the vHBA with the FCoE VLAN. Follow the instructions
in to assign the VLAN.
•
After making configuration changes, you must reboot the host for settings to take effect.
Viewing vHBA Properties
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters the command mode for the adapter card at the
PCI slot number specified by index.
Server /chassis # scope adapter index
Step 2
The server must be powered on before you
can view or change adapter settings.
Note
Displays properties of a single vHBA, if specified, or
all vHBAs.
Server /chassis/adapter # show
host-fc-if [fc0 | fc1 | name] [detail]
Step 3
This example displays all vHBAs on adapter card 1 and the detailed properties of fc0:
Server# scope chassis
Server /chassis # scope adapter 1
Server /chassis/adapter # show host-fc-if
Name World Wide Port Name FC SAN Boot Uplink Port
-------- ------------------------ ----------- -----------
fc0 20:00:00:22:BD:D6:5C:35 Disabled 0
fc1 20:00:00:22:BD:D6:5C:36 Disabled 1
Server /chassis/adapter # show host-fc-if fc0 detail
Name fc0:
World Wide Node Name: 10:00:00:22:BD:D6:5C:35
World Wide Port Name: 20:00:00:22:BD:D6:5C:35
FC SAN Boot: Disabled
Persistent LUN Binding: Disabled
Uplink Port: 0
MAC Address: 00:22:BD:D6:5C:35
CoS: 3
VLAN: NONE
Rate Limiting: OFF
PCIe Device Order: ANY
EDTOV: 2000
RATOV: 10000
Maximum Data Field Size: 2112
Channel Number: 3
Port Profile:
Server /chassis/adapter #
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 87
Managing Network Adapters
Viewing vHBA Properties