Router Instructions

Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router

Connectors and Cables

Cisco uBR10-SRP-OC12SML DPT WAN Line Card

78-13602-01

Connectors and Cables

The Cisco uBR10-SRP-OC12SML DPT WAN line card uses a single-mode fiber-optic interface cable to

connect the Cisco uBR10012 router to another router or switch. See Figure 6 on page 7.

Single-mode cables are yellow.

Note Single-mode fiber-optic cables are not available from Cisco Systems.

For SONET or SDH single-mode fiber-optic connections, use one duplex SC-type connector (Figure 4)

or two simplex SC-type connectors. See Figure 5.

Figure 4 Duplex SC Cable Connector

Figure 5 Simplex SC Cable Connector

You can use either a duplex fiber cable or two simplex fiber cables between the DPT port line and the

device to which the DPT port line is connected. If you are using an attenuator with the cable, see Figure 6

on page 7.

Table 2 Cable Specification

Fiber Type Wavelength, nm Core Size, microns Cable Distance

Single-mode fiber 1310 8 to 10 49,213 - 131,234 ft.

(15 - 40 km)

H2214

H2399