user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
3-9
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 3 Configuring Open Shortest Path First (OSPF)
CSS OSPF Configuration Quick Start
OSPF IP Interface Configuration Quick Start
To configure OSPF on a CSS IP interface, see the steps in Table 3-2. In the most
basic IP interface configuration, you need to perform only steps 1 through 4, and
step 7 to:
• Assign OSPF to the IP interface
• Associate OSPF with the globally defined area, if this is an area other than
the backbone area (0.0.0.0)
• Enable OSPF on the interface
This configuration example assumes you will accept the default OSPF
configuration settings for the interface, except the router priority. The interface
OSPF configuration settings include:
• Intervals for the hello packet, LSA retransmission, and link-state update
packet
• Authentication password
• CSS router priority
• Interface cost
For more information on configuring these OSPF IP interface settings, see the
“Configuring OSPF on a CSS IP Interface”section.
Table 3-2 Configuration Quick Start for OSPF on a CSS Interface
Task and Command Example
1. Access global configuration mode. Enter:
# config
2. Access the circuit configuration mode for a preconfigured circuit on which
you want to create the IP interface. For example, if circuit VLAN6 already
exists, enter:
(config)# circuit VLAN6
(config-circuit[VLAN6])#
Note Refer to Chapter 1, Configuring Interfaces and Circuits for information
on how to configure the CSS interfaces and circuits and the bridge
interfaces to VLANs.