user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
3-7
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 3 Configuring Open Shortest Path First (OSPF)
CSS OSPF Configuration Quick Start
CSS OSPF Configuration Quick Start
This section includes the following topics:
• Global OSPF Configuration Quick Start
• OSPF IP Interface Configuration Quick Start
• Verifying Your Configuration
Global OSPF Configuration Quick Start
To perform the global OSPF configuration for the CSS, see the steps in Table 3-1.
In the most basic global configuration, where the CSS functions as a router in the
OSPF backbone area, you need to perform only steps 1 and 2 to:
• Define the CSS router ID
• Enable OSPF
Optionally, you can define the CSS:
• In an area other than the backbone, including a stub area.
• As an ABR, by configuring route summarization.
• As an ASBR, to advertise non-OSPF routes through OSPF, as AS-external
routes such as static and RIP routes. You could also advertise VIP addresses
for content as AS external routes.
After performing the global OSPF configuration, you must configure an OSPF IP
interface (see the “OSPF IP Interface Configuration Quick Start” section) before
the CSS can participate in OSPF routing. For more information on configuring
global OSPF parameters, see the “Configuring OSPF on the CSS” section.