user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 2 Configuring Spanning-Tree Bridging for the CSS
Showing Bridge Configurations
2-6
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
To disable spanning-tree bridging, enter:
(config)# bridge spanning-tree disable
To reenable spanning-tree bridging, enter:
(config)# bridge spanning-tree enable
Showing Bridge Configurations
Use the show bridge forwarding command to display bridge forwarding
information. Table 2-2 describes the fields in the show bridge forwarding
command output.
Use the show bridge status command to display bridge status information.
Table 2-3 describes the fields in the show bridge status output.
Table 2-2 Field Descriptions for the show bridge forwarding Command
Field Description
VLAN The bridge interface virtual LAN number
MAC Address The MAC address for the entries
Port Number The port number used for bridge forwarding
Table 2-3 Field Descriptions for the show bridge status Command
Field Description
STP State The state of the Spanning-Tree Protocol: Enabled or
Disabled.
Root Max Age The timeout period, in seconds, during which the host times
out root information.
Root Hello Time The interval, in seconds, during which the root bridge
broadcasts its hello message to other devices.
Root Fwd Delay The delay time, in seconds, that the root bridge uses for
forward delay.
Designated Root The bridge ID for the designated root.