user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 2 Configuring Spanning-Tree Bridging for the CSS
CSS Spanning-Tree Bridging Quick Start
2-2
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
This chapter contains the following major sections:
• CSS Spanning-Tree Bridging Quick Start
• Configuring Spanning-Tree Bridge Aging-Time
• Configuring Spanning-Tree Bridge Forward-Time
• Configuring Spanning-Tree Bridge Hello-Time
• Configuring Spanning-Tree Bridge Max-Age
• Configuring Spanning-Tree Bridge Priority
• Disabling Bridge Spanning-Tree
• Showing Bridge Configurations
For details about configuring spanning-tree bridging parameter for an Ethernet
interface or for a trunked Ethernet interface and VLAN pair, refer to Chapter 1,
Configuring Interfaces and Circuits.
CSS Spanning-Tree Bridging Quick Start
Table 2-1 provides a quick overview of the steps required to globally configure
spanning-tree bridging for the CSS. Each step includes the CLI command
required to complete the task. For a complete description of each feature and all
the options associated with the CLI command, see the sections following
Table 2-1.
Table 2-1 Spanning-Tree Bridging Configuration Quick Start
Task and Command Example
1. Set the bridge filtering database aging time, in seconds, for the CSS.
(config)# bridge aging-time 600
2. Set the bridge forward delay time, in seconds, that the bridge uses when
acting as the root.
(config)# bridge forward-time 9
3. Set the bridge hello time interval, in seconds, that the bridge waits before
sending a hello packet.
(config)# bridge hello-time 9