user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
vii
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Contents
Setting the Cost 3-25
Setting the Dead Router Interval 3-25
Setting the Hello Packet Interval 3-25
Setting the Password 3-26
Setting the Poll Interval 3-26
Setting the Priority of the CSS 3-27
Setting the Retransmission Interval 3-27
Setting the Transit-Link Delay 3-28
Showing OSPF Information 3-28
Showing OSPF Area Information 3-29
Showing Global Statistics 3-29
Showing IP Interface Information 3-30
Showing Link-State Databases 3-33
Showing ASE Entries 3-36
Showing the Configured Advertised ASE Routes 3-37
Showing the Redistribution Policy 3-38
Showing Summary Route Configuration Information 3-39
Showing OSPF Neighbors 3-39
OSPF Configuration in a Startup-Configuration File 3-43
CHAPTER
4 Configuring the Address Resolution Protocol 4-1
ARP Configuration Quick Start 4-2
Configuring ARP 4-3
Configuring ARP Timeout 4-4
Configuring ARP Wait 4-4
Updating ARP Parameters 4-5
Clearing ARP Parameters 4-5
Showing ARP Information 4-6