user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Contents
vi
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
CHAPTER
3 Configuring Open Shortest Path First (OSPF) 3-1
OSPF Overview 3-2
OSPF Routing Hierarchy 3-3
Autonomous System 3-4
Areas 3-4
Backbone Area 3-4
Area Border Routers 3-5
Stub Area 3-5
Autonomous System Boundary Routers 3-5
Link-State Databases 3-6
CSS OSPF Configuration Quick Start 3-7
Global OSPF Configuration Quick Start 3-7
OSPF IP Interface Configuration Quick Start 3-9
Verifying Your Configuration 3-11
Configuring OSPF on the CSS 3-12
Configuring the OSPF Router ID 3-12
Enabling OSPF 3-13
Configuring an Area 3-13
Removing an Area 3-14
Configuring Equal-Cost Routes 3-14
Configuring Summarized Routes at an ABR 3-14
Configuring the CSS as an Autonomous System Boundary Router 3-15
Advertising a Route as an OSPF ASE Route 3-16
Advertising a Default ASE Route 3-20
Advertising Other Routes Through OSPF 3-21
Configuring OSPF on a CSS IP Interface 3-22
Configuring the CSS IP Interface as an OSPF Interface 3-23
Assigning an OSPF Area to the Interface 3-24
Enabling OSPF on the Interface 3-24
Configuring the Interface Attributes 3-24