user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 1 Configuring Interfaces and Circuits
Configuring Interfaces
1-30
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
To shut down all interfaces, enter:
# admin-shutdown
Restarting an Interface
To restart an interface, use the no admin-shutdown or no shut command. For
example:
• To restart interface e3 on the CSS 11501 with the no admin-shutdown
command, enter:
(config-if[e3])# no admin-shutdown
• To restart interface e3 on the CSS 11501 with the no shut command, enter:
(config-if[e3])# no admin-shutdown
Note The CSS automatically sends a gratuitous ARP for the IP interface address when
you restart the interface. The gratuitous ARP informs all network nodes about
ARP mapping. The CSS transmits one ARP request packet and one ARP reply
packet for every gratuitous ARP invocation.
Restarting All Interfaces
To restart all interfaces, enter:
# no admin-shutdown
Note The CSS automatically sends a gratuitous ARP for every configured IP interface
address when you restart all interfaces. The gratuitous ARP informs all network
nodes about ARP mapping. The CSS transmits one ARP request packet and one
ARP reply packet for every gratuitous ARP invocation.