user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 1 Configuring Interfaces and Circuits
Configuring Interfaces
1-28
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Single Collision The number of successfully transmitted frames on the
interface for transmissions that were inhibited by exactly
one collision.
Multiple
Collisions
The number of successfully transmitted frames on the
interface for transmissions that were inhibited by more than
one collision.
SQE Test The number of times that the SQE TEST ERROR message
is generated.
Deferred Tx The number of frames for which the first transmission
attempt on the interface is delayed because the medium is
busy.
The count represented by an instance of this object does not
include frames involved in collisions.
Internal Rx Errors The number of frames for which reception on the interface
failed due to an internal MAC sublayer receive error.
Frame too Long The number of frames received on the interface that
exceeded the maximum permitted frame size.
Carrier Sense
Errors
The number of times that the carrier sense condition was
lost or never asserted when attempting to transmit a frame
on the interface.
Internal Tx Errors The number of frames for which transmission on the
interface failed due to an internal MAC sublayer transmit
error.
Excessive
Collisions
The number of frames for which transmission on the
interface failed due to excessive collisions.
Late Collisions The number of times that a collision is detected on the
interface later than 512 bit-times in to the transmission of a
packet.
Table 1-9 Field Descriptions for the show ether-errors Command (continued)
Field Description