user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 1 Configuring Interfaces and Circuits
Configuring Interfaces
1-24
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Table 1-7 describes the fields in the show phy command output.
Showing Interface Statistics
Use the show mibii command to display the extended 64-bit MIB-II statistics for
a specific interface, or for all interfaces in the CSS. The CSS Enterprise ap64Stats
MIB defines these statistics. The Gigabit Ethernet module port statistics are an
aggregation of all ports on the module.
To display the RFC 1213 32-bit statistics, include the
-32 suffix.
To display extended MIB-II statistics for a specific interface in the CSS, enter the
show mibii command with the interface name. To see a list of interfaces in the
CSS, enter show mibii ?.
Note Refer to the Cisco Content Services Switch Administration Guide for information
on CSS MIBs.
Table 1-7 Field Descriptions for the show phy Command
Field Description
Name The name of the physical interface.
Configured Speed The configured speed for the Ethernet interface (port) in
the CSS. Auto indicates the speed is automatically
negotiated.
Configured Duplex The configured duplex for the Ethernet interface (port) in
the CSS. Auto indicates the duplex is automatically
negotiated.
Actual Speed The actual speed for the Ethernet interface (port) in the
CSS.
Actual Duplex The configure duplex for the Ethernet interface (port) in
the CSS.
Link The link status: Up or Down.
Rev Revision number of the chip.
Partner Auto Indicates whether auto-negotiation is available on the
link partner.