user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
v
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Contents
Configuring Router-Discovery Protocol Settings for a Circuit 1-34
Configuring the Router-Discovery Lifetime 1-35
Configuring Router-Discovery Limited-Broadcast 1-35
Configuring the Router-Discovery Max-Advertisement-Interval 1-36
Configuring the Router-Discovery Min-Advertisement-Interval 1-36
Showing Circuits 1-37
Showing IP Interfaces 1-38
Configuring RIP for an IP Interface 1-39
Enabling RIP on an IP Interface 1-39
Configuring a RIP Default Route 1-40
Configuring a RIP Receive Version 1-40
Configuring RIP Send Version 1-40
Configuring RIP Packet Logging 1-41
Showing RIP Configurations for IP Addresses 1-41
Configuring the Switched Port Analyzer Feature 1-44
Configuring SPAN on a CSS 1-46
Verifying the SPAN Configuration on a CSS 1-47
CHAPTER
2 Configuring Spanning-Tree Bridging for the CSS 2-1
CSS Spanning-Tree Bridging Quick Start 2-2
Configuring Spanning-Tree Bridge Aging-Time 2-3
Configuring Spanning-Tree Bridge Forward-Time 2-4
Configuring Spanning-Tree Bridge Hello-Time 2-4
Configuring Spanning-Tree Bridge Max-Age 2-4
Configuring Spanning-Tree Bridge Priority 2-5
Disabling Bridge Spanning-Tree 2-5
Showing Bridge Configurations 2-6