user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 1 Configuring Interfaces and Circuits
Configuring Interfaces
1-20
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
To display bridge forwarding or bridge status for a specific VLAN in the CSS,
enter the show bridge forwarding or the show bridge status command with the
VLAN number. Entering the show bridge command with a VLAN number returns
a list of available VLANs.
Table 1-3 describes the fields in the show bridge forwarding command output.
Table 1-4 describes the fields in the show bridge status command output.
Table 1-3 Field Descriptions for the show bridge forwarding Command
Field Description
VLAN The bridge interface virtual LAN number
MAC Address The MAC address for the entries
Port Number The port number for the bridge forwarding table
Table 1-4 Field Descriptions for the show bridge status
Command
Field Description
STP State The state of the Spanning-Tree Protocol: Enabled or
Disabled.
Root Max Age The timeout period, in seconds, during which the host times
out root information.
Root Hello Time The interval, in seconds, that the root bridge broadcasts its
hello message to other CSSs.
Root Fwd Delay The delay time, in seconds, that the root bridge uses for
forward delay.
Designated Root The bridge ID for the designated root.
Bridge ID The bridge ID of this bridge.
Port The port ID.