user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
1-19
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 1 Configuring Interfaces and Circuits
Configuring Interfaces
Showing Interface Configurations
This CSS includes a series of show interface mode commands that enable you to
view interface configuration information about the CSS. This information
includes VLAN bridging, VLAN trunk status, list of valid Ethernet interfaces,
interface duplex and speed values, interface statistics, and errors on an Ethernet
interface.
This section includes the following topics:
• Showing Bridge Configurations
• Showing Trunking Configurations
• Showing Interface Information
• Showing Interface Duplex and Speed
• Showing Interface Statistics
• Showing Ethernet Interface Errors
Showing Bridge Configurations
The CSS enables you to show bridging information for a specific VLAN in the
CSS. Use the show bridge command to display this bridging information.
The syntax for this command is:
show bridge [forwarding|status] {vlan_number}
The options and variables are as follows:
• forwarding - Displays the bridge forwarding table including the VLAN
number, the MAC addresses, and port numbers.
• status - Displays the bridge spanning-tree status including the Spanning Tree
Protocol (STP) state; designated root; bridge ID; root maximum age; hello
time and forward delay; and port information including state, VLAN, root
and port cost, and designated root and port number.
• vlan_number - Displays the forwarding table or spanning tree status for the
specified VLAN number. To see a list of VLAN numbers, enter show bridge
[forwarding|status] ?