user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Contents
iv
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Specifying VLAN Trunking for an Interface 1-11
Selecting a Default VLAN in a Trunk 1-13
Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface 1-14
Configuring Spanning-Tree Bridge Pathcost 1-15
Configuring Spanning-Tree Bridge Port Priority 1-15
Configuring Spanning-Tree Bridge State 1-16
Configuring Port Fast on an Interface 1-16
Enabling Port Fast 1-17
Enabling BPDU Guard 1-17
Showing Port Fast Information 1-18
Showing Interface Configurations 1-19
Showing Bridge Configurations 1-19
Showing Trunking Configurations 1-22
Showing Interface Information 1-22
Showing Interface Duplex and Speed 1-23
Showing Interface Statistics 1-24
Showing Ethernet Interface Errors 1-27
Shutting Down an Interface 1-29
Shutting Down All Interfaces 1-29
Restarting an Interface 1-30
Restarting All Interfaces 1-30
Configuring Circuits 1-31
Entering Circuit Configuration Mode 1-31
Configuring a Circuit IP Interface 1-31
Configuring a Circuit IP Address 1-32
Configuring a Circuit-IP Broadcast Address 1-32
Configuring Circuit-IP Redirects 1-33
Configuring Circuit-IP Unreachables 1-33
Configuring Router-Discovery Preference for a Circuit IP Interface 1-33
Enabling and Disabling a Circuit IP 1-34