user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
1-3
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 1 Configuring Interfaces and Circuits
Interface and Circuit Overview
Figure 1-1 illustrates the interfaces, circuits, and VLANs in a CSS, and Figure 1-2
illustrates trunking between VLANs.
Figure 1-1 CSS Interfaces and Circuits
Figure 1-2 Interface Trunking Between VLANs
Bridging
Domain
vlan 1
Interface Port e1
Interface Port e2
Interface Port e3
Interface Port e4
10.3.6.58
Circuit
IP Interface
for VLAN 1
IP Forwarding
(Layer 3)
VLAN1
Bridging
Domain
vlan 2
Interface Port e5
Interface Port e7
Interface Port e9
Interface Port e11
10.3.6.59
Circuit
IP Interface
for VLAN 2
VLAN2
Bridging
Domain
vlan 3
Interface Port e6
Interface Port e8
Interface Port e10
Interface Port e12
10.3.6.60
Circuit
IP Interface
for VLAN 3
VLAN3
49384
51593
VLAN1 VLAN1
Trunk
CSS 1 CSS 2
VLAN2 VLAN2
VLAN1 and VLAN2