user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Index
IN-6
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
OSPF IP interface
running-config example
3-10
P
packet storms, preventing 2-5
panning-tree bridging
running-config example
2-3
pathcost, configuring for bridging 1-15
port
analyzing
1-44
auto-negotiate 1-8
configuring Port Fast 1-16
DSPAN 1-44
enabling BPDU guard 1-17
enabling Port Fast 1-17
interfaces, configuring 1-6
mirroring 1-44
monitoring 1-44
SSPAN 1-44
Port. See also interface
Port Fast
BPDU guard
1-17
configuring 1-16
displaying information 1-18
enabling 1-17
priority, configuring for bridging 1-15
protocol
ARP, configuring
4-1
CDP, configuring 7-1
IP, configuring 6-1
publications, obtaining additional xxiv
Q
quick start
interface and circuit
1-4
OSPF 3-7
R
redundancy, disabling 6-8
removing
DHCP relay destination address
8-3
IP address from a circuit 1-32
restarting an interface 1-30
restoring
bridge path cost default value
1-15
bridge priority default value 1-15
bridge state default value 1-16
broadcast IP address 1-32
default aging-time 2-3
default bridge forward time 2-4
default bridge hello-time 2-4
default bridge max-age 2-5
default bridge priority 1-15