user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 7 Configuring the Cisco Discovery Protocol
CDP Configuration Quick Start
7-2
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
This chapter contains the following major sections:
• CDP Configuration Quick Start
• Enabling CDP
• Setting the CDP Hold Time
• Setting the CDP Transmission Rate
• Showing CDP Information
CDP Configuration Quick Start
Table 7-1 provides a quick overview of the steps required to configure CDP for
the CSS. Each step includes the CLI command required to complete the task. For
a complete description of each feature and all the options associated with the CLI
command, see the sections following Tabl e 7-1.
Table 7-1 CDP Configuration Quick Start
Task and Command Example
1. Enable CDP transmissions from the CSS to other neighboring Cisco
CDP-compatible devices on the network.
(config)# cdp run
2. Specify the amount of time a receiving device retains the CDP information
sent by the CSS (time-to-live information) before discarding this
information.
(config)# cdp holdTime 255
3. Specify the frequency at which the CSS transmits CDP packets to all
receiving CDP-compatible devices.
(config)# cdp timer 120
4. (Recommended) Display and verify CDP information for the CSS.
(config)# show cdp