user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 6 Configuring the Internet Protocol
Showing IP Configuration Information
6-20
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Resetting IP Statistics
To set the global IP (TCP/UDP) statistics for the CSS to zero, use the zero ip
statistics command in any mode. This command sets the TCP/UDP statistics
displayed by the show ip statistics command to zero. For more information about
the show ip statistics command, see the “Showing IP Statistics” section.
Showing a Summary of IP Global Statistics
Use the show ip summary command to display a summary of IP global statistics.
The statistics include data on reachable and total routes, reachable and total hosts,
memory in use for each, and total IP routing memory in use.
Table 6-6 describes the fields in the show ip summary command output.
Replies Out The sending ARP reply packet count.
In Off Subnet The number of received ARP packets with sender or
target addresses outside of the subnet range of the
receiving interface.
Unresolved The number of processed IP frames with unresolved
next hop MAC addresses.
Table 6-5 Field Descriptions for the show ip statistics Command (continued)
Field Description
Table 6-6 Field Descriptions for the show ip summary Command
Field Description
Reachable Routes The current number of reachable routes.
Total Routes The current number of routes maintained, both reachable
and unreachable.
Reachable Hosts The current number of reachable host entries.