user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
6-19
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 6 Configuring the Internet Protocol
Showing IP Configuration Information
Echo Requests Out The number of transmitted ICMP Echo request
messages. Typically, when the CSS transmits an ICMP
request, both the Echo Requests Out and the Echo
Replies In counters increment as a pair for the ICMP
request out and ICMP reply in packets.
Echo Replies Out The number of transmitted ICMP Echo reply
messages.Typically, when the CSS transmits an ICMP
reply, both the Echo Requests In and the Echo Replies
Out counters increment as a pair for the ICMP reply
out and ICMP request in packets.
Source Quench The number of received ICMP Source Quench
messages.
Router Adv The number of received ICMP router advertisement
packets.
Time Exceeded The number of received ICMP Time Exceeded
messages.
Timestamp The number of sent ICMP Timestamp (request)
messages.
Information Request The number of received ICMP information request
packets.
Mask Request The number of sent ICMP Address Mask Request
messages.
Invalid The number of received bad ICMP type packets.
ARP Statistics
Requests In The number of received ARP request packets.
Requests Out The number of sending ARP request packets.
Duplicate Addr The number of received ARP packets with a detected
duplicate IP address. The duplicate IP address can be
the local IP address, VIP, or virtual interface.
Invalid The number of invalid or bad ARP packets.
Replies In The number of received ARP reply packets.
Table 6-5 Field Descriptions for the show ip statistics Command (continued)
Field Description