user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 6 Configuring the Internet Protocol
Showing IP Configuration Information
6-16
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Showing IP Statistics
Use the show ip statistics command to display aggregate TCP statistics for the
unit. Table 6-5 describes the fields in the show ip statistics output.
If The Index value that identifies the local interface through
which the next hop of this route should be reached.
Type The type of the route entry. The possible types are as follows:
• local - Local interface
• remote - Remote destination
• mgmt - Management interface
Proto The protocol for the route.
Age The maximum age of the route.
Metric The metric cost of the route.
Table 6-4 Field Descriptions for the show ip routes Command (continued)
Field Description
Table 6-5 Field Descriptions for the show ip statistics Command
Field Description
UDP Statistics
Input Datagrams The total number of flow-related UDP datagrams
delivered to UDP users.
No Port Errors The total number of received UDP datagrams for
which there was no application at the destination port.
Output Datagrams The total number of flow-related UDP datagrams sent
from the CSS.
Input Errors The number of received UDP datagrams that could not
be delivered for reasons other than the lack of an
application at the destination port.