user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
6-13
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 6 Configuring the Internet Protocol
Showing IP Configuration Information
Showing IP Global Configuration Parameters
Use the show ip config command to display IP global configuration parameters.
These parameters show the state (enabled or disabled) of the source route option,
forward IP broadcasts, record-route option, and IP route change logging. The
show ip config command also shows the value for the orphaned route timer.
Table 6-2 describes the fields in the show ip config output.
Table 6-2 Field Descriptions for the show ip config Command
Field Description
Source Route
Option
Indicates whether processing of source-routed frames is
enabled or disabled.
Forward IP
Broadcasts
Indicates whether forwarding IP broadcasts is enabled or
disabled.
Orphaned Route
Timer
The setting for the orphaned route timer.
Record Route
Option
Indicates whether processing with the record-route option
is enabled or disabled.
Multiple Equal
Cost Path
Algorithm
The setting for the equal-cost multipath selection
algorithm. The possible settings are as follows:
• Address - Choose among alternate paths based on IP
addresses
• Roundrobin - Alternate between equal paths in
roundrobin fashion
IP Route Change
Logging
Indicates whether logging IP route changes is enabled or
disabled.