user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 6 Configuring the Internet Protocol
IP Configuration Quick Start
6-2
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
IP Configuration Quick Start
Table 6-1 provides a quick overview of the steps required to setup the IP
configuration for the CSS. Each step includes the CLI command required to
complete the task. For a complete description of each feature and all the options
associated with the CLI command, see the sections following Table 6-1.
Table 6-1 IP Configuration Quick Start
Task and Command Example
1. Configure an IP route for the CSS. You can configure a static route, default
route, a blackhole route, or a firewall route. For example, to configure a
static IP route, enter:
(config)# ip route 192.168.0.0 /16 192.167.1.1
2. (Optional) If you do not want the CSS to start an implicit service for the next
hop of a static route, specify that no implicit service is established to the
next hop of the static route. By default the CSS establishes an implicit
service for the gateway address when a static route is defined.
(config)# ip no-implicit-service
3. (Optional) Enable box-to-box redundancy to provide chassis-level
redundancy between two identically configured CSSs.
(config)# ip redundancy
4. (Optional) Set the equal-cost multipath (ECMP) selection algorithm and the
preferred reverse egress path.
(config)# ip ecmp address
5. (Optional) Enable the CSS to forward subnet broadcast addressed frames.
(config)# ip subnet-broadcast
6. (Recommended) Display IP information for the CSS. For example, to
display IP routing information, enter:
# show ip routes