user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 4 Configuring the Address Resolution Protocol
Showing ARP Information
4-8
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
To display the global ARP configuration, enter:
# show arp config
Table 4-4 describes the fields in the show arp config command output.
To display the host IP addresses entered at initialization or boot time through
ARP, enter:
# show arp file
To display the ARP entries from the CSS management port, enter:
# show arp management-port
Table 4-5 describes the fields in the show arp management-port command
output.
Table 4-4 Field Descriptions for the show arp config Command
Field Description
ARP Response Timeout The time, in seconds, to wait for an ARP resolution
response before discarding the packet waiting to be
forwarded to an address. The time can be from 5 to 30
seconds. The default is 5 seconds.
ARP Flush Timeout The time, in seconds, to hold an ARP resolution result
in the ARP cache. The timeout period can be from 60
to 86400 seconds (24 hours). The default is 14400
seconds (4 hours). An entry of none or 86401
indicates the ARP entries will not timeout.
Table 4-5 Field Descriptions for the show arp management-port Command
Field Description
IP Address The IP address of the system for ARP mapping.
MAC Address The MAC address of the system mapped to the IP address.
Port The CSS Ethernet management port.