user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 3 Configuring Open Shortest Path First (OSPF)
Showing OSPF Information
3-38
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Showing the Redistribution Policy
To show the configured redistribution policy into OSPF, enter:
# show ospf redistribute
Table 3-9 describes the fields in the show ospf redistribute command output.
Table 3-9 Field Descriptions for the show ospf redistribute
Command
Static, RIP, Local, or
Firewall Field Description
Routes
Redistribution
Indicates whether the redistribution of static, RIP, local
or firewall routes is enabled or disabled. If route
redistribution is enabled, the configured metric, type, and
tag fields are displayed.
Route Metric
(displayed when
redistribution is
enabled)
The external cost for the route. The cost can range from
1 to 16777215. The default is 1.
Route Type
(displayed when
redistribution is
enabled)
The ASE type, either ASE Type1 or ASE Type2. By
default, the type is aseType2. The difference between
type1 and type2 is how the cost is calculated. For a type 2
ASE, only the external cost (metric) is used when
comparing multiple paths to the same destination. For
type1 ASE, the combination of the external cost and the
cost to reach the ASBR is used.
Route Tag
(displayed when
redistribution is
enabled)
The 32-bit tag value to advertise the external route. The
route tag value is not used by the OSPF protocol itself. It
is used to communicate information between AS
boundary routers.