user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
3-37
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 3 Configuring Open Shortest Path First (OSPF)
Showing OSPF Information
Showing the Configured Advertised ASE Routes
To show the configuration of ASE routes into OSPF, enter:
# show ospf advertise
To show the configuration of ASE routes into OSPF for a specific host, include
the IP address or host and the subnet mask. Enter the address in dotted-decimal
format (for example, 192.168.11.1) or mnemonic host-name format (for example,
myname.mydomain.com). Enter the mask either:
• As a prefix length in CIDR bit-count notation (for example, /24). Do not enter
a space to separate the IP address from the prefix length.
• In dotted-decimal notation (for example, 255.255.255.0).
For example:
# show ospf advertise 192.168.11.1/24
Table 3-8 describes the fields in the show ospf advertise command output.
Table 3-8 Field Descriptions for the show ospf advertise Command
Field Description
Prefix The IP address for the route. For the CSS, the prefix is
predominately VIP addresses.
Prefix Length The prefix length for the IP address.
Metric The network cost for the route. The range is from 1 to
16777215. The default is 1.
Type The ASE type for the route. By default, the ASE type is ASE
type2, which is the external cost to reach the route. ASE type1
combines the external and internal costs.
Tag The 32-bit tag value to advertise the route. The value is not used
by OSPF.