user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
3-23
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 3 Configuring Open Shortest Path First (OSPF)
Configuring OSPF on a CSS IP Interface
Configuring the CSS IP Interface as an OSPF Interface
An OSPF interface is an IP interface that you configure to send and receive OSPF
traffic. To configure the CSS IP interface as an OSPF interface, use the ospf
command.
Note You mus t e n te r t he ospf command before the ospf enable command can take
effect.
To configure the CSS IP interface as an OSPF interface:
1. Access the circuit configuration mode for the preconfigured circuit on which
you want to create the IP interface. For example, if circuit VLAN6 already
exists, enter:
(config)# circuit VLAN6
(config-circuit[VLAN6])#
Note Refer to Chapter 1, Configuring Interfaces and Circuits for information
on how to configure the CSS interfaces and circuits, and bridge interfaces
to VLANs.
2. Create the IP interface to the circuit. To create an IP address of 3.1.2.2, enter:
(config-circuit[VLAN6])# ip address 3.1.2.2/24
Create ip interface <3.1.2.2>, [y/n]:y
3. Configure this circuit as an OSPF circuit. Enter:
(config-circuit-ip[VLAN6-3.1.2.2])# ospf