user manual
Table Of Contents
- Cisco Content Services Switch Routing and Bridging Configuration Guide
- Contents
- Preface
- Configuring Interfaces and Circuits
- Interface and Circuit Overview
- Configuring Interfaces
- Configuring an Interface
- Entering a Description for the Interface
- Configuring Interface Duplex and Speed
- Setting Interface Maximum Idle Time
- Bridging an Interface to a VLAN
- Specifying VLAN Trunking for an Interface
- Configuring Spanning-Tree Bridging for a VLAN or a Trunked Interface
- Configuring Port Fast on an Interface
- Showing Interface Configurations
- Shutting Down an Interface
- Shutting Down All Interfaces
- Restarting an Interface
- Restarting All Interfaces
- Configuring Circuits
- Configuring RIP for an IP Interface
- Configuring the Switched Port Analyzer Feature
- Configuring Spanning-Tree Bridging for the CSS
- CSS Spanning-Tree Bridging Quick Start
- Configuring Spanning-Tree Bridge Aging-Time
- Configuring Spanning-Tree Bridge Forward-Time
- Configuring Spanning-Tree Bridge Hello-Time
- Configuring Spanning-Tree Bridge Max-Age
- Configuring Spanning-Tree Bridge Priority
- Disabling Bridge Spanning-Tree
- Showing Bridge Configurations
- Configuring Open Shortest Path First (OSPF)
- OSPF Overview
- CSS OSPF Configuration Quick Start
- Configuring OSPF on the CSS
- Configuring OSPF on a CSS IP Interface
- Showing OSPF Information
- OSPF Configuration in a Startup-Configuration File
- Configuring the Address Resolution Protocol
- Configuring Routing Information Protocol
- Configuring the Internet Protocol
- IP Configuration Quick Start
- Configuring an IP Route
- Disabling an Implicit Service for the Static Route Next Hop
- Configuring an IP Source Route
- Configuring the IP Record Route
- Configuring Box-to-Box Redundancy
- Configuring IP Equal-Cost Multipath
- Forwarding IP Subnet Broadcast Addressed Frames
- Configuring IP Unconditional Bridging
- Configuring IP Opportunistic Layer 3 Forwarding
- Showing IP Configuration Information
- Configuring the Cisco Discovery Protocol
- Configuring the DHCP Relay Agent
- Index
Chapter 3 Configuring Open Shortest Path First (OSPF)
Configuring OSPF on a CSS IP Interface
3-22
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Optionally, you can define any of the following:
• The network cost for the route by including the metric option. Enter a
number from 1 to 16,777,215
. The default is 1.
• A 32-bit tag value to advertise each external route by including the tag option.
The 32-bit tag value is not used by the OSPF protocol itself. You can use the
tag value to communicate information between AS boundary routers.
• The advertised routes as ASE type1 by including the type1 option. By
default, the type is ASE type2. The difference between type1 and type2 is
how the cost is calculated. For a type2 ASE, only the external cost (metric) is
considered when comparing multiple paths to the same destination. For type1
ASE, the combination of the external cost and the cost to reach the ASBR is
used.
For example:
(config)# ospf redistribute rip metric 3 type1
To stop advertising the RIP routes via OSPF, enter:
(config)# no ospf redistribute rip
Configuring OSPF on a CSS IP Interface
When you configure a CSS IP interface as an OSPF interface, you define its
behavior and role within the OSPF routing domain. This section includes the
following topics:
• Configuring the CSS IP Interface as an OSPF Interface
• Assigning an OSPF Area to the Interface
• Enabling OSPF on the Interface
• Configuring the Interface Attributes