User manual

Removing and Installing Power Supplies
Book Title
4-14
Figure 4-9 Terminal Block and Captive Screws
Step 4
Disconnect the DC-input wires from the terminal block. (See Figure 4-9.)
Caution Disconnect the ground wire last.
Step 5 Loosen and remove the captive screws on the sides of the power supply with a
screwdriver. (See Figure 4-9.)
Caution Alternate loosening the captive installation screws every one or two turns to
avoid skewing the power supply.
Step 6 Grasp the DC power supply handle with one hand and slowly pull the power
supply out of the chassis toward you. (See Figure 4-10.)
INPUT
48/60
14.0/8.0 A
H9794
Captive
screws
Terminal block