User's Manual

Cisco SPA302D 5
Registering the Handset to the Cisco SPA232D Mobility
Enhanced ATA
STEP 1 Install and configure the Cisco SPA232D. See the Cisco SPA232D
Quick Start Guide for more information.
STEP 2 On the Cisco SPA302 handset, press the Select button in the
center of the 4-way navigation keypad.
STEP 5 Select Register.
STEP 6 On the Cisco SPA232D, press the Page/Registration button and
hold it down for at least seven seconds until the green status light
flashes quickly.
TIP If you press the button for fewer than seven seconds, the
green status light flashes slowly, indicating the unit is in
“paging” mode and is not in registration mode. Registration
will not work if the unit is in paging mode.
STEP 3
S
TEP 4
Using the navigation arrows, scroll to the Settings icon
and press the center navigation button to select it.
Select Handset Registration.