User's Manual

4 Cisco SPA302D
Handset Setup and Registration
Charging the Handset
STEP 1 Remove the back cover of the handset.
STEP 2 Insert the two AAA rechargeable batteries (included) into the
handset. (See Battery Warning in “Before You Begin.”)
Correct battery placement is shown on the label inside the battery
compartment. If the batteries are charged, the handset turns on
when the batteries are inserted. If the batteries are not charged,
the handset turns on when it is placed into the charging cradle.
STEP 3 Remove the protective film from the handset and charging cradle.
STEP 4 Insert the power clip into the power adapter.
STEP 5 Plug the power adapter into the power source.
STEP 6 Connect the power adapter into the charging cradle in the port
shown below.
CAUTION Only use the power adapter designed for use with Cisco
SPA300 Series devices.
STEP 7 Place the handset into the charging cradle. The light on the
charging cradle appears solid green when the handset is charging.
Charge the handset for a minimum of 10 hours before using the
handset for the first time to ensure that the handset is fully charged.