Network Router User Manual

Configuring Secure Domain Routers on Cisco IOS XR Software
How to Configure Secure Domain Routers
SMC-160
Cisco IOS XR System Management Configuration Guide
Step 7
Log in to the non-owner SDR using admin plane
authentication:
Username:xxxx@admin
Password:xxxx
Example:
Username:xxxx@admin
Password:xxxx
Logs a root-system user into the SDR using admin plane
authentication.
Note Where it says “Username:xxxx@admin,” replace
xxxx with your username.
Step 8
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters configuration mode.
Step 9
username username
Example:
RP/0/RP0/CPU0:router(config)# username user1
Defines an SDR username and enters username
configuration mode.
The user-name argument can be only one word. Spaces and
quotation marks are not allowed.
Step 10
secret password
Example:
RP/0/RP0/CPU0:router(config-un)# secret 5 XXXX
Defines a password for the user.
Step 11
group root-lr
Example:
RP/0/RP0/CPU0:router(config-un)# group root-lr
Adds the user to the predefined root-lr group.
Note Only users with root-system authority or root-lr
authority may use this option.
Step 12
end
or
commit
Example:
RP/0/RP0/CPU0:router (config)# end
or
RP/0/RP0/CPU0:router(config)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found. Commit them?
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
– Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
– Entering cancel leaves the user in the same
command mode without committing the
configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Step 13
exit
Example:
exit
Closes the active terminal session and log off the router.
Command or Action Purpose