Network Router User Manual

Configuring Secure Domain Routers on Cisco IOS XR Software
How to Configure Secure Domain Routers
SMC-155
Cisco IOS XR System Management Configuration Guide
Step 4
no location partially-qualified-nodeid
Example:
RP/0/0/CPU0:router(admin-config-sdr:rname2
)#
no location 0/0/*
Removes a node from a non-owner SDR.
• When a node is removed from an SDR, it is automatically
added to the owner SDR inventory. This node may now be
assigned to a different SDR, as described in the “Adding
Nodes to an SDR in a Cisco XR 12000 Series Router”
section on page SMC-150.
• Removing all the slots from an SDR deletes that SDR.
To remove a DSDRSC
The DSDRSC cannot be removed if other nodes are in the SDR
configuration. To remove the DSDRSC, you must first remove all
other nodes in the SDR.
To remove a single node
Enter the no location partially-qualified-nodeid command. The
value of the partially-qualified-nodeid argument is entered in the
rack/slot/* notation. Node IDs are always specified at the slot
level, so the wildcard (*) is used to specify the CPU.
Step 5
end
or
commit
Example:
RP/0/RP0/CPU0:router
(admin-config-sdr:rname2)# end
or
RP/0/RP0/CPU0:router(admin-config-sdr:rnam
e2)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found. Commit them?
– Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
– Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
– Entering cancel leaves the user in the same command
mode without committing the configuration changes.
• Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Command or Action Purpose