user manual

2-11
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 2 Installing and Configuring Cisco HSI Software
Starting the Cisco HSI
Dual HSI Example Configuration Script
The following example script configures the network topology depicted in Figure 2-1.
Example
HSI-A (Blue network)
prov-add:name="SYS_CONFIG_STATIC",HOST_PORT_NUMBER1="9001"
prov-add:name="SYS_CONFIG_STATIC",HOST_PORT_NUMBER2="0"
prov-add:name="SYS_CONFIG_STATIC",VSCA_IPADDR1="194.182.147.242"
prov-add:name="SYS_CONFIG_STATIC",VSCA_IPADDR2="194.182.147.242"
prov-add:name="SYS_CONFIG_STATIC",VSCA_PORT_NUMBER1="8003"
prov-add:name="SYS_CONFIG_STATIC",VSCA_PORT_NUMBER2="8003"
prov-add:name="SYS_CONFIG_STATIC",VSCB_IPADDR1="194.182.147.243"
prov-add:name="SYS_CONFIG_STATIC",VSCB_IPADDR2="194.182.147.243"
prov-add:name="SYS_CONFIG_STATIC",VSCB_PORT_NUMBER1="8003"
prov-add:name="SYS_CONFIG_STATIC",VSCB_PORT_NUMBER2="8003"
HSI-B (Red network)
prov-add:name="SYS_CONFIG_STATIC",HOST_PORT_NUMBER1="9002"
prov-add:name="SYS_CONFIG_STATIC",HOST_PORT_NUMBER2="0"
prov-add:name="SYS_CONFIG_STATIC",VSCA_IPADDR1="194.182.147.226"
prov-add:name="SYS_CONFIG_STATIC",VSCA_IPADDR2="194.182.147.226"
prov-add:name="SYS_CONFIG_STATIC",VSCA_PORT_NUMBER1="8004"
prov-add:name="SYS_CONFIG_STATIC",VSCA_PORT_NUMBER2="8004"
prov-add:name="SYS_CONFIG_STATIC",VSCB_IPADDR1="194.182.147.227"
prov-add:name="SYS_CONFIG_STATIC",VSCB_IPADDR2="194.182.147.227"
prov-add:name="SYS_CONFIG_STATIC",VSCB_PORT_NUMBER1="8004"
prov-add:name="SYS_CONFIG_STATIC",VSCB_PORT_NUMBER2="8004"
Starting the Cisco HSI
To start the Cisco HSI, execute the start script as the root user and enter the following command:
# /etc/init.d/CiscoGW start
Note The application runs as root user because this is a requirement of a Simple Network Management
Protocol (SNMP) subagent application. If you do not run this script as the root user, the SNMP subagent
fails to connect to the master agent.