user manual

2-7
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 2 Installing and Configuring Cisco HSI Software
Installing the Cisco HSI
Step 14 Type the gatekeeper ID (see Table 2-2) and press Enter.
Note The gatekeeper ID must match the entry configured in the gatekeeper.
The following text displays:
Enter E-ISUP Host Port
Step 15 Type the E-ISUP host port (see Table 2-2) and press Enter.
Note The E-ISUP host port is typically 8003, but it must match the peer port setting of the IPLNK
object in the PGW 2200 configuration.
The following text displays:
Enter VSC1 Name
Step 16 Type the VSC1 name and press Enter.
Note The VSCI name is either the DNS host name (if DNS is configured) or the IP address of the
PGW 2200.
The following text displays:
Enter VSC1 Port
Step 17 Type the VSC1 port number (see Table 2-2) and press Enter.
Note The VSCI port is typically 8003, but it must match the port setting of the IPLNK object in the
PGW 2200 configuration.
The following text displays:
Enter Installation NodeId
Step 18 Type the installation node ID (see Table 2-2) and press Enter.
Note The installation node ID is a text field typically used by network designers for identification
purposes. Entering a value in this field does not affect functionality.
The following text displays:
Enter Hardware Platform
Step 19 Type the hardware platform name (see Table 2-2) and press Enter (typically, accept the default platform
name). The following text displays:
Enter Installation Location