user manual
2-6
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 2 Installing and Configuring Cisco HSI Software
Installing the Cisco HSI
Step 5 At the # prompt, enter the following commands:
# cd /export/BUILDS/4.1
# ./install.sh
The following text displays:
Processing package instance <OTTgw000> from </export/BUILDS/4.1/APPLICATIONS/OTTgw000.pkg>
GoldWing H323 Adjunct Processor V0.1.6
(sparc) 4.1
Copyright (c) 2001 Cisco Systems, Ltd.
All Rights Reserved
This product is protected by copyright and distributed under
licenses restricting copying, distribution and decompilation.
Enter GoldWing base directory path (default /opt/GoldWing) [?,q]
Step 6 Press Enter to select the default HSI base directory path.
Caution We strongly recommend that you select the default base directory path. Operational issues
might arise if other directories are used.
The following text displays:
Enter base directory path (default /opt/GoldWing/4.1) [?,q]
Step 7 Press Enter to select the default base directory path. The following text displays:
Enter GoldWing user name
Step 8 Type the Cisco HSI user name mgcusr and press Enter (the default user name is cisco). The following
text displays:
Enter GoldWing group name
Step 9 Type the Cisco HSI group name mgcgrp and press Enter (the default user group name is sysadmin). The
following text displays:
Enter GateKeeper IP Address
Step 10 Type the gatekeeper IP address (see Table 2-2) and press Enter. The following text displays:
Enter GateKeeper Port
Step 11 Type the gatekeeper port (see Table 2-2) and press Enter (the default port is 1719). The following text
displays:
Enter GateWay Prefix
Step 12 Type the gateway prefix (see Table 2-2) and press Enter.
Note The gateway prefix is the prefix that, when dialed from the H.323 network, causes the Cisco HSI
to route the call over E-ISUP to the PGW 2200.
The following text displays:
Enter Terminal Alias
Step 13 Type the terminal alias (see Table 2-2) and press Enter. The following text displays:
Enter GateKeeper Id