user manual

A-10
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Appendix A MML User Interface and Command Reference
diaglog
Examples In this example, a measurement counter, GK_DISC_ATT_TOT (Gatekeeper Discovery Attempts), is
reset in the counter group RAS:
gw mml> clr-meas:RAS
GW Signaling Interface 2000-12-05 14:19:22
M SUCC
mml>
mml> clr-meas:RAS:name=GK_DISC_ATT_TOT
GW Signaling Interface 2000-12-05 14:19:22
M SUCC
Related Commands
diaglog
The diaglog command starts and stops event logging into a diagnostics log.
diaglog:file name:start | stop
Syntax Description
Examples In this example, event logging is started in a diagnostics log named test5.
gw mml> diaglog:test5:start
test5_davek15823_20010130053323.log
In the preceding example, davek is the user who runs the command, and 15823 is the process ID of the
MML process from which the command is run.
Related Commands
Command Description
rtrv-ctr Displays the measurements for a counter group.
file name The user-defined name of the log file. The actual file name has a .log suffix
applied. The file is located in the logging directory defined in the
configuration data (see
Chapter 3, “Provisioning the Cisco HSI”).
Command Description
radlog Starts and stops RADVision logging into a specified log file.
rtrv-log Displays the logging level of a package or all packages.
set-log Sets the logging level of a package or all packages.