user manual

A-3
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Appendix A MML User Interface and Command Reference
Starting an MML Session
The MML commands can be interpreted and monitored through a network Transaction Language 1
(TL1) interface. The TL1 symbols shown in
Table A-2 are used in MML
.
Case Sensitivity
Command names and parameter names are not case sensitive You can enter commands and parameters
in either upper- or lowercase. Filenames are case sensitive when they are used as arguments in MML
commands.
Starting an MML Session
To start an MML session, complete the following steps:
Step 1 Log in to Cisco HSI.
Step 2 Type one of the following commands at the prompt:
• mml
• mml -b batchfile (see the “Starting a Batch File” section on page A-4)
The following example shows the start of an MML session:
user@host> mml
Welcome to the Cisco H.323 Signaling Interface.
gw mml>
Ta b l e A-2 TL1 Symbols Used in MML
Symbol Description
: A parameter separator.
:: An empty parameter block.
& Arguments are grouped together so that one parameter can convey several
arguments.
; End of command (optional). Anything on the same line after this symbol is treated
as a comment.