User Guide

10 Cisco 350 Series Managed Switches
If this is the first time that you have logged on with the default
username and password, the following message appears:
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [Y]?
STEP 5 Enter Y, and set a new administrator password.
NOTE Password complexity is enabled by default. The password
must comply with the default complexity rules.
CAUTION Make sure that any configuration changes made are saved
before exiting.
You are now ready to configure the switch. Refer to www.cisco.com/go/
350switches to locate the CLI Guide for your switch.
NOTE If you are not using DHCP on your network, set the IP address type
on the switch to Static and change the static IP address and subnet mask
to match your network topology. Failure to do so may result in multiple
switches using the same factory default IP address of 192.168.1.254.
Cisco 350 Series Switch Features
This section describes the exterior of the switch to help familiarize you
with your switch.
Product Models
Model Description
SF350-48 48-Port 10/100 Managed Switch
SF350-48P 48-Port 10/100 PoE Managed Switch
SF350-48MP 48-Port 10/100 PoE Managed Switch
SG350-8PD 8-Port 2.5 Gigabit PoE Managed Switch
SG350-28 28-Port Gigabit Managed Switch
SG350-28P 28-Port Gigabit PoE Managed Switch
SG350-28MP 28-Port Gigabit PoE Managed Switch
SG350-10 10-Port Gigabit Managed Switch
SG350-10P 10-Port Gigabit PoE Managed Switch
5