Router Installation and Configuration Guide

5-4
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-02
Chapter 5 Connecting the Management Interfaces
Connecting the Management Interface
Connecting the Management Interface
The SCE8000-SCM-E is equipped with one active RJ-45 management port. This port provides access
from a remote management console to the Cisco SCE8000 via a LAN.
The procedures for cabling the GBE management port and testing connectivity between the Cisco
SCE8000 and the remote management host are explained in the following sections.
• How to Cable the Management Port, page 5-4
• How to Verify Management Interface Connectivity, page 5-5
How to Cable the Management Port
The SCE8000-SCM-E has one GBE port that is used as the management port, located in slot# 1 of the
Cisco SCE8000 chassis, and labeled Port1.
Step 1 Plug the Ethernet cable provided (with attached RJ-45 connector) into Port 1on the front panel of the
SCE8000-SCM-E. (See item #3 in Figure 5-2 below.)
Figure 5-2 Cabling the Management Port
270976
S
CE8000-SCM-E
1
0/
1
00/
1
00
0
L
INK
/
ACTIVE
OPTICAL
BYPASS1
CONSOLE
PORT1
1
2
3