Network Router User Manual

Chapter 6 Cabling the Line Ports and Completing the Installation
Connecting the line ports to the network
Cisco SCE 1000 2xGBE Installation and Configuration Guide
6-4 OL-7821-04
To configure GBE auto-negotiation for speed and duplex for the first GBE port (subscriber side)
interface:
Step 1 To enter the Global Configuration Mode, at the SCE 1000# prompt, type configure, and press
Enter.
The SCE 1000(config)# prompt appears.
Step 2 To enter the first GBE port interface, type interface GigabitEthernet 0/1, and press Enter.
The SCE 1000(config if)# prompt appears.
Step 3 Type auto-negotiate and press Enter.
The SCE 1000(config if)# prompt appears.
Step 4 To return to Global Configuration Mode, type exit and press Enter.
The SCE 1000(config)# prompt appears.
Follow the next procedure to configure auto-negotiation for the second GBE port interface
To configure speed and duplex for the second GBE port (network side) interface:
Step 1 At the SCE 1000(config)# prompt, to enter the second GBE port interface, type interface
GigabitEthernet 0/2, and press Enter.
The SCE 1000(config if)# prompt appears.
Step 2 Type auto-negotiate and press Enter.
The SCE 1000(config if)# prompt appears.
Step 3 To return to Global Configuration Mode, type exit and press Enter.
The SCE 1000(config)# prompt appears.
Step 4 To exit Global Configuration Mode, type exit and press Enter.
The SCE 1000# prompt appears.
Note
Auto-negotiation must be disabled when the SCE 1000 is deployed via an external optical splitter (i.e.
receive-only topology).