Network Router User Manual

13-19
Cisco 7304 Router Modular Services Card and Shared Port Adapter Software Configuration Guide
OL-4807-02
Chapter 13 Configuring the 2-Port and 4-Port T3/E3 SPAs
Configuration Examples
No FEAC code is being received
MDL transmission is disabled
Configuration Examples
This section includes the following configuration examples:
• DSU Configuration Example, page 13-19
• MDL Configuration Example, page 13-19
• Scrambling Configuration Example, page 13-20
• Framing Configuration Example, page 13-20
• Encapsulation Configuration Example, page 13-20
• Cable Length Configuration Example, page 13-20
• Invert Data Configuration Example, page 13-21
• Trace Trail Buffer Configuration Example, page 13-21
DSU Configuration Example
The following example confgiures DSU on interface port 0 on slot 4, subslot 1.
! Specify the serial interface and enter interface configuration mode
!
Router(config)# interface serial 4/1/0
!
! Specify the DSU mode
!
Router(config-if)# dsu mode 0
!
! Specify the DSU bandwidth
!
Router(config-if)# dsu bandwidth 10000
!
! Set the DSU bandwidth to accept or reject the incoming remote requests
!
Router(config-if)# dsu remote accept
MDL Configuration Example
The following example configures the MDL strings on interface port 0 on slot 4, subslot 1.
! Specify the serial interface and enter interface configuration mode
!
Router(config)# interface serial 4/1/0
!
! Specify the MDL strings
!
Router(config-if)# mdl string eic beic
Router(config-if)# mdl string lic beic
Router(config-if)# mdl string fic bfix
Router(config-if)# mdl string unit bunit
Router(config-if)# mdl string pfi bpfi
Router(config-if)# mdl string port bport
Router(config-if)# mdl string generator bgen