Network Router User Manual

2-17
Cisco 806 Router Hardware Installation Guide
78-10432-01
Chapter 2 Installation
Where to Go from Here
Where to Go from Here
You have completed the hardware installation and are ready to configure the
software. Cisco strongly recommends that inexperienced network administrators
use the Cisco Router Web Setup application that has been installed on the router.
To use this application, complete the following steps:
Step 1 Log on to one of the PCs connected to the router through ETHERNET port 1, 2,
3, or 4.
Step 2 Open a web browser.
Step 3 Type in the following universal resource locator (URL):
http://10.10.10.1
Step 4 Click the Router Setup link in the Cisco Router Web Setup home page, and
follow the instructions that appear in the page that is displayed.
Step 5 If the web page does not appear when you enter the URL http://10.10.10.1, test
the connection between the PC and the router by doing the following:
a. Check that the OK LED on the router is on, and check the cable connection
between the router and the PC. If the PC you are using is connected to
Ethernet port number 4, be sure that the TO HUB/TO PC button is in the TO
PC position.
b. If the CRWS home page still does not appear, verify that your web browser’s
work offline option is disabled.
c. If the web page still does not appear, verify that your PC is automatically
configured to receive an IP address, by following the instructions in Cisco
Router Web Setup User Guide, which is available on the Cisco
800 and SOHO Series Product Documentation CD.