Router Getting Started Guide

2-6
Cisco IOS XR Getting Started Guide
OL-10957-02
Chapter 2 Bringing Up the Cisco IOS XR Software on a Standalone Router
Verifying the System After Initial Bring-Up
hfr-base, V 3.3.0[2I], Cisco Systems, at disk0:hfr-base-3.3.0
Built on Mon Mar 13 11:43:22 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
hfr-os-mbi, V 3.3.0[2I], Cisco Systems, at disk0:hfr-os-mbi-3.3.0
Built on Mon Mar 13 11:27:02 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
--More--
show environment Command
To display environmental monitor parameters for the system, use the show environment command in
EXEC or administration EXEC mode. The following command syntax is used:
show environment [options]
Enter the show environment ? command to display the command options.
In the following example, temperature information for a Cisco CRS-1 router is shown:
RP/0/RP0/CPU0:router# show environment temperatures
R/S/I Modules Inlet Exhaust Hotspot
Temperature Temperature Temperature
(deg C) (deg C) (deg C)
0/1/*
host 32, 30 26, 27 35
cpu 34
fabricq0 27
fabricq1 32
ingressq 37
egressq 32 27
ingresspse 35
egresspse 29
jacket 25 24 25
spa0 19 25, 32
spa5 25 24
0/6/*
host 32, 26 27, 25 33
cpu 35
fabricq0 27
fabricq1 32
ingressq 37
egressq 30 25
ingresspse 31
egresspse 29
jacket 24 25 26
spa0 19 25, 31
spa4 22 33, 35
spa5 24 24
0/RP0/*
host 23 24 24, 33, 26,
24, 27
0/RP1/*
host 23 24 24, 32, 26,
24, 26
In the following example, LED status of the nodes in a Cisco CRS-1 router is shown:
RP/0/RP0/CPU0:router# show environment leds