Router Getting Started Guide

2-5
Cisco IOS XR Getting Started Guide
OL-10957-02
Chapter 2 Bringing Up the Cisco IOS XR Software on a Standalone Router
Verifying the System After Initial Bring-Up
Examples of show Commands
The following sections provide examples of show commands:
• show version Command, page 2-5
• show environment Command, page 2-6
• show platform Command, page 2-7
• show redundancy Command, page 2-8
show version Command
To display basic information about the router configuration, type the show version command in EXEC
mode, as shown in the following example:
RP/0/RP0/CPU0:router# show version
Cisco IOS XR Software, Version 3.3.0[2I]
Copyright (c) 2006 by cisco Systems, Inc.
ROM: System Bootstrap, Version 1.38(20050525:193559) [CRS-1 ROMMON],
CRS-8_P1 uptime is 1 week, 1 day, 17 hours, 1 minute
System image file is "disk0:hfr-os-mbi-3.3.0/mbihfr-rp.vm"
cisco CRS-8/S (7457) processor with 4194304K bytes of memory.
7457 processor at 1197Mhz, Revision 1.2
16 Packet over SONET/SDH network interface(s)
16 SONET/SDH Port controller(s)
2 Ethernet/IEEE 802.3 interface(s)
16 GigabitEthernet/IEEE 802.3 interface(s)
2043k bytes of non-volatile configuration memory.
38079M bytes of hard disk.
1000592k bytes of ATA PCMCIA card at disk 0 (Sector size 512 bytes).
1000640k bytes of ATA PCMCIA card at disk 1 (Sector size 512 bytes).
Package active on node 0/1/SP:
hfr-diags, V 3.3.0[2I], Cisco Systems, at disk0:hfr-diags-3.3.0
Built on Mon Mar 13 12:58:02 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
hfr-admin, V 3.3.0[2I], Cisco Systems, at disk0:hfr-admin-3.3.0
Built on Mon Mar 13 11:46:36 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
Step 3
show redundancy
Example:
RP/0/RP0/CPU0:router# show redundancy
Displays the state of the primary (active) and standby (inactive)
RPs, including the ability of the standby to take control of the
system.
• If both RPs are working correctly, one node displays active
role, the Partner node row displays standby role, and the
Standby node row displays Ready.
Step 4
show environment
Example:
RP/0/RP0/CPU0:router# show environment
Displays information about the hardware attributes and status.
Command or Action Purpose