Router Installation and Configuration Guide

Index
IN-6
Cisco 7204 Installation and Configuration Guide
OL-5101-02
replacing or recovering a lost password 6-13
reviewing changes to configuration 4-11
RFI 2-5
RIP 4-6
RJ-45 port, I/O controller
crossover cable
3-19
straight-through cable 3-19
RJ-45 port on I/O controller, pinouts 3-18
Routing Information Protocol
See RIP
4-6
S
safety recommendations 2-1
saving the configuration file 4-9, 4-10
service adapters
physical description
1-17
subsystem for troubleshooting 5-7
setup command 4-4
setup command facility 2-11
example 4-6
script
banner information (example)
4-4
interface summary (example) 4-5
System Configuration Dialog (example) 4-5
setup command facility configuration, basic 4-4
show diag command 1-16, 6-1
show environment command 1-28, 2-9
show environment last command 1-28
show environment table command 1-29
show interfaces command 1-24
show running-config command 4-11
show startup-config command 4-11
show version command 1-10, 6-1
shutdown
environmental
1-26
fan failure 1-30
power supply 1-27
processor 1-27
thresholds 1-26
SIMM configurations, network processing engine 1-10
Simple Network Management Protocol
See SNMP
4-6
site log 2-14
site requirements 2-4
environment 2-8
equipment racks 2-6
plant wiring 2-4
power 2-4
preventive configuration 2-9
slot/port numbers for interfaces 1-24
SNMP 4-6
SNMP management 1-7
software requirements 1-6
startup, system 3-23
status
environmental
1-28, 2-9
interfaces 1-24
straight-through cable, RJ-45 port on I/O controller 3-19
subsystems for troubleshooting
cooling
5-7
I/O controller 5-6
network processing engine 5-6
port adapters 5-7
power 5-5
service adapters 5-7
switch
emergency power
2-3
power 1-18
synchronous serial interfaces, configuring 4-8
system specifications 1-5
T
telco-type equipment racks 2-6
telephone jacks 2-3
temperature, internal chassis 1-26
terminology xiii