Router Installation and Configuration Guide

Index
IN-4
Cisco 7204 Installation and Configuration Guide
OL-5101-02
connecting I/O controller cables 3-13
connecting port adapter cables 3-13
connecting power 3-20
grounding the chassis 3-11
initial configuration information 2-11
installing brackets on the chassis 3-5
installing chassis in a rack 3-1
installing chassis on a tabletop (general
installation)
3-9
interface parameters 4-7
preparing for 2-1
safety recommendations 2-1
site requirements 2-4
starting the Cisco 7204 3-23
tools for 2-10
interface
configuration
4-7
parameters 4-7
interference, radio frequency 2-5
Interior Gateway Routing Protocol (IGRP) 4-6
interior routing protocol (IGRP), setting 4-6
Internet Package Exchange (IPX), configuring 4-6
IP, setting routing protocols for 4-6
IPX 4-6
J
jewelry, avoiding for safety 2-2
L
LEDs
DC OK
3-23
enabled on interface processors 3-24
I/O controller 1-13, 5-3
PCMCIA slots 0 and 1 1-16
power supply 1-18, 5-3
lifting the chassis 2-2, 3-9
lightning storm, safety during 2-3
M
messages
environmental
1-28
fan failure 2-9
MII port on I/O controller, pinouts 3-17
modifications to configuration, reviewing 4-11
N
network processing engine
components
1-7
DRAM configurations 1-10
handling 2-3
physical description 1-6
subsystem for troubleshooting 5-6
system management functions 1-7
nonvolatile random-acess memory
See NVRAM
4-10
normal status level, environmental monitor 1-27, 1-28
note, description of ix
numbering
logical interface
1-23
port adapter slot 1-23
NVRAM
log
1-27
saving and viewing contents 4-10
See nonvolatile random-access memory
O
OIR, functional description 1-25
operating conditions for chassis 1-19, 2-4
out-of-tolerance temperature condition 1-27
out-of-tolerance voltage condition 1-27
overheating, preventing 2-9
overtemperature conditions 5-3