Router Installation and Configuration Guide

Index
IN-2
Cisco 7204 Installation and Configuration Guide
OL-5101-02
show version 1-10, 6-1
config terminal command 4-10
configuration
file, saving
4-9, 4-10
interface 4-7
modifications 4-11
reviewing modifications 4-11
configuration bit meanings B-5
configuration modes, basic 4-10
configuration procedures
AutoInstall
4-2
basic router configuration 4-2
Ethernet interface configuration 4-7
I/O controller Fast Ethernet full-duplex
configuration
1-17
I/O controller Fast Ethernet media type
configuration
1-17
setup command facility 4-4
synchronous serial interface configuration 4-8
configuration register B-5
configure command 4-10
configuring
AppleTalk
4-6
global parameters
description
4-4
procedure 4-5
sample configuration 4-6
interface parameters
examples of
4-7, 4-8
sample configuration 4-8 to 4-9
interfaces 4-7
IPX 4-6
the router
using AutoInstall
4-2
using configuration mode 4-10
using the setup command facility 4-4
configuring global parameters 4-4
connecting power 3-20
connection equipment
auxiliary port signals
3-16
console and auxiliary 3-14
console port signals 3-15
Fast Ethernet MII and RJ-45 on I/O controller 3-16
connector
auxiliary port
3-16
console port 3-15
console port cable 3-15
console terminal, system banner display 5-5
cooling subsystem 5-3, 5-7
copy command 6-9
copy command (Flash memory) 6-11
copy running-config startup-config command 4-3, 4-10
critical status level, environmental monitor 1-27
crossover cable, RJ-45 port on I/O controller 3-19
D
damage from overheating 1-26
DC power
shutdown
1-27
displays, environmental 1-28
distance limitations, transmission 2-5
E
EEPROM, MAC address bank 1-25
electromagnetic pulse (EMP), avoiding 2-5
electrostatic discharge, preventing 2-3
EMI, shielding 2-3
enable command 4-10
enable password 4-1
enable secret password 4-1
environmental monitor, description 1-26
environmental monitoring and reporting
power thresholds
1-27
Ethernet, interface configuration parameters 4-7
examples